Get matched with top above ground pool installation pros in Dover, ID

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

A solar cover can heat your pool anywhere from 5 to 15 degrees Fahrenheit over the course of 6 to 12 hours, depending on how much full sun your pool gets and how big it is. When used in conjunction with a solar pool heater, your pool will heat up even faster, all while using less energy than a traditional pool heater.

High alkalinity, which is above seven on the pH scale, is the result of improper chemical levels in the pool. Each chemical you use to keep your pool clean has a different pH, so a ratio that isn't optimized for your pool size may cause the number to go above 7.8, the high end for a good pH range in most swimming pools.

Most importantly, you should never cut corners when building a pool. Whether it’s an in-ground or aboveground, poorly constructed pools are dangerous to both the swimmers and your property. Leaks can even lead to home foundation damage. While you can DIY smaller elements of pool installation, always hire a contractor to oversee the process.