Top-rated contractors.

Best contractors near Moville, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Moville, IA?

Select your specific project to find the pro for you.

Top-Rated Contractors in Moville - Updated Nov 2026

Avatar for Chris Pierce Construction, LLC
Chris Pierce Construction, LLC
5.0(
6
)
Major Home Repairs (General Contractor)

Serving Moville, IA and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"Chris did a good job was donein less than a week everythingall cleaned up. Beautiful job thank you. Would hire him againin a minute. Thought it was spendy but everything is today."
Backsplash
Backsplash
Small rear deck
Small Rear Deck
The Finished Product

+10

Response time1 day
Response rate98%
1 neighbors recently requested a quote
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Moville, IA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Moville, IA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Showing 1-10 of 29
Unfinished Carpentry FAQs, answered by experts

When hanging a door frame, it’s recommended that you use screws, not nails. Screws are more secure, easier to tighten, and easier to remove if you need to adjust the frame. On average, the cost to replace a door frame is about $400, but you can save on labor costs if you’re confident in your ability to DIY the project. 

You can enclose an open carport, however, there are several things to consider before opting to do so. You'll want to check local building codes and permit requirements before proceeding to make sure it’s legal. While you can sometimes stick-frame a carport enclosure, pre-fab kits are also available. Remember that you'll likely need to meet concrete slab regulations and provide lighting inside the structure. Both of which could substantially drive up costs.

You should avoid drilling or cutting into load-bearing beams because removing material will weaken it and increase the risk of structural damage or even collapse. If you do need to drill into a load-bearing beam, speak with a structural engineer first to discuss where it’s safest to drill and the width and depth of the bit that’s safe to use.

No rules state how much of a load-bearing wall can be removed. Rather, you need to adequately support any area that is removed. Support should always be added to as much wall area is being removed. Failing to support the area properly will result in structural damage.

Yes, professional installations include reinforced corner posts to ensure durability.

The Moville, IA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.