Top-rated contractors.

Best contractors near Lawton, IA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Lawton, IA?

Select your specific project to find the pro for you.

Top-Rated Contractors in Lawton - Updated Nov 2026

Avatar for Chris Pierce Construction, LLC
Chris Pierce Construction, LLC
5.0(
6
)
Major Home Repairs (General Contractor)

Serving Lawton, IA and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"Chris did a good job was donein less than a week everythingall cleaned up. Beautiful job thank you. Would hire him againin a minute. Thought it was spendy but everything is today."
Backsplash
Backsplash
Small rear deck
Small Rear Deck
The Finished Product

+10

Response time1 day
Response rate98%
1 neighbors recently requested a quote
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Lawton, IA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Lawton, IA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
DBI Contractor, Inc
New to Angi
Major Home Repairs (General Contractor)

Serving Lawton, IA and surrounding areas

In business since 2002

Dittbenner Builders maintains the highest standards of project management and workmanship. We staff our projects with a supervisor and a team of the most experienced carpenters and other tradesmen. \n \nOur clients receive the finest quality workmanship and the most cost effective performance available, in keeping with their highest expectations and ours. \n \nWhether the project is large or small, we develop a carefully coordinated strategy that meets all project needs. \n \nWorking closely with the home or business owner we ensure that the project is thoroughly planned and carefully coordinated. \n \nThen we deliver top quality services that follow the approved plans, follow all specifications, and meet all required codes and acceptable standards ... explicitly, within budget and on schedule.

Showing 1-10 of 28
Unfinished Carpentry FAQs, answered by experts

There are a few easy ways to locate a wall stud without a stud finder. First, try knocking on the wall with your knuckles. Most parts of the wall will sound hollow, but when you tap over a stud, it will sound more solid. Alternatively, since studs are spaced 16 or 24 inches apart, you can measure those distances from a corner of the room, which will always have a stud.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

Accurate measurements, sturdy materials, and seamless integration with other structures.

A-frame homes are on the smaller side. While there’s no set square footage amount it has to be, it will usually come in around 1,000 square feet or smaller.

The Lawton, IA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.