Get matched with top dryer vent cleaners in Grand Junction, IA

If you're dealing with an odor in your dryer that transfers onto your clothes and linens, here's what you can do: start by cleaning the lint trap and drum with warm soapy water. Then wipe down the interior using a mixture of equal parts water and white vinegar to eliminate any lingering odors.

To get rid of odors you can try this method: take a cloth soaked in vinegar and put it inside the dryer. Run the dryer on a heat setting for 15 minutes. Afterward, make sure to dry the drum by running it with some towels. This technique helps eliminate any smells and leaves your dryer smelling nice and fresh.

If the odors remain, you may need to sanitize your dryer or call in a professional house cleaner to handle the job.

Dryer vent cleaning costs around $150 on average, and most homeowners pay between $75 and $350 for the service. There are a few factors that affect your pricing, including the following:

• Length of the dryer vent

• Whether the vent is rigid or flexible

• Accessibility of your dryer vent

• Amount of lint needed to remove from the vent

According to the Department of Energy, around 15,000 house fires are started every year from clogged dryer vents. It might seem expensive, but dryer vent cleaning can help you avoid severe house fires, injury, and even death.

It’s possible to clean your dryer vent yourself in most cases, but it’s usually best to leave this important task to a professional. If you make a mistake when reinstalling the vent, you could kink it, which makes it easier for a blockage to form. Instead, call in a professional annually to do a thorough cleaning and an inspection. They will make sure there are no kinks in the vent that could promote blockages in addition to cleaning it. If your vent runs through a wall, you’ll need help from a professional regardless.

You’ll find the backdraft damper near the top of the range hood (where it connects to the ductwork). However, some range hoods also have a second damper, which is located close to the roof or exterior wall where the ductwork ends. If you don’t see a damper in either of these places, you might not have one.