Get matched with top drywall pros in De Witt, IA

Knowing what causes drywall damage can help stop it before it starts. Here are some of the most common causes of drywall damage: 

• Water damage from roof leaks or leaky pipes. 

• Small holes caused by doorknobs, minor accidents, and rodent infestations. 

• Wall dents stemming from moving furniture and minor accidents. 

• Wall cracks that form from a settling foundation or seismic activity. 

• Nail pops from nails and screws in the walls. 

• Large holes that are caused by accidents with heavy objects, children and pets, or sporting equipment.

Yes, cabinets are installed over drywall. The drywall must be in good condition, and you must ensure that the wall can handle the weight of the cabinets. Secure the cabinets to studs and use proper anchoring devices, like toggle bolts.

Although they have similar applications, spackle and joint compound are not the same. Their primary differences lie in their composition, consistency, and ideal use cases.

Spackle is composed of gypsum and binding agents, making it thicker than joint compound. It dries quickly and is easy to sand, which makes it ideal for small wall repair projects like filling nail holes or patching minor damage.

Joint compound, also known as drywall mud, consists of limestone and gypsum. It is primarily used for large-scale projects, such as taping and finishing the seams on newly installed drywall. It tends to shrink more than spackle and can be more difficult to spread.

While both products can be used to fill small depressions and cracks, spackle cannot replace joint compound for taping and mudding new drywall. Conversely, you can often use joint compound for small patching jobs typically done with spackle.

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.