Get matched with top insulation pros in Waimea, HI

The heat loss through a poorly insulated attic when you’re running your furnace or heat pump during cold weather can be as high as 25%. This means you could see significantly higher energy costs to make up for this heat loss. The cost of adding insulation to the attic may eventually pay for itself through lower energy bills. If you decide to add a radiant barrier too, the radiant barrier cost may also pay for itself over time.

Unfaced wall insulation is easier to cut and install, making it the better choice for a DIY project. It’s also more affordable. But if it’s unfaced, you’ll likely need to add a vapor barrier to reach your desired R-value and efficiency, as it doesn’t offer any moisture barrier.

Faced insulation uses paper or foil to create a built-in barrier and doesn’t require an extra step. It’s also more fire-resistant and safe. But it’s quite a bit more expensive and a little bit harder to work with as a DIYer.

Yes, covering exposed wires is necessary for several important reasons. Exposed electrical wires pose significant risks, such as electrical shocks, fires, short circuits, and potential damage to your home’s electrical system. By properly insulating and protecting the wires, you can minimize the potential for accidents, prevent electrical fires, and ensure your electrical system stays intact. 

Asphalt roofs provide better insulation than metal roofs, but that doesn’t always mean that asphalt roofs are better for reducing heating and cooling bills. In hotter climates, metal roofs will usually be better for home efficiency because the material reflects more sunlight and reduces solar heat gain. In colder climates, asphalt roofs are sometimes superior in terms of efficiency because they introduce more solar heat gain to your home and have greater insulating capabilities. However, metal roofs installed with an air gap can provide similar levels of insulation.