Lumpkin Concrete bringing your concrete dreams to reality. We specialize in flat work, home foundations and building projects as well as driveways, porches and patios. We also specialize in decorative concrete such as stamped and stained concrete. So if you’re looking for a well qualified company to take care of your concrete needs look no further, and estimates are always free of charge.
I started my own business in March of 2026doing Concrete, Pavers and Masonry. I have 5 years of experience. I take pride in making my work perfect and being priced fair.
I am a veteran so I know exactly what it is that needs to be done. I always complete the job that we agreed upon any timely manner. I have years of experience in the masonry business as well as the concrete business you will be getting a professional job.
"Very well. The slight dip in the kitchen looks better and the doors trued up. The slight sag still in the kitchen floor is because of the sub floor plywood which I didn't want to get in to. They leveled the joist by shimming the tops of several cinder block posts and installing a pair permanent of steel posts under a section of joist the previous owner had cut in two."
"Very impressed from the start to finish. They were very careful cutting down the pine tree that was so close to the house using a bucket truck. Taking it down piece by piece. Ron was very Knowledgeable about Pecan trees and helped me make a decision to trim one our 100+ year old trees and saved it from toppling over. Will use them again."
"Overall, it was a good experience. AAA put down a vapor barrier and installed a Santa Fe dehumidifier with sump pump. The result is that we can now use the stand-up basement/crawlspace to store things under the house without ruining them. This is the part that you need to know. The installation was not without problems. First, they broke an A/C drain pipe, second, they cut a sprinkler controller wire while running a PVC pipe. Here's my take, accidents happen but how does the business respond to these issues? Well, Donna was very quick to send her team out to correct the problems and they even paid for the damage to the sprinkler system. To me, that's top notch customer service. Any business can make a mistake, but how they handle it is the mark of a good company. Every time I lift the roll door and go into the basement now, I'm amazed at how cool and fresh the air is down there. No more mildew and no more smell."
Freeman Concrete & Masonry, is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers interests and make their concerns the basis of our business
I would like to recommend the company Crawl Space Doctor. This is actually a very easy recommendation for me to make because the company is that good! The quality workmanship by the employees under direct supervision by this locally owned and operated company is exactly what we were looking for when I chose this contractor.
The owner is Greg McBride. I found that he has been in business in and around the Savannah area for approximately 10 years. Moving to Savannah over 10 years ago, he and his family are now permanent residents and "natives." With Crawl Space Doctor I found that personal relationship that you find with a craftsman that you can trust and depend on. In fact, I shopped around and got estimates up to $17,000. Each job is different, but I can tell you that trust is built when you have a company tell you that they can up the price, but "I am not going to sell something if not needed." In fact, one of the reasons that I am writing this letter is because there was a little more dampness found under the house than expected. Rather than use the standard grade liner, he upgraded the liner to a thicker millimeter grade, because that is what was he assessed was needed at the time. Of course, I was a little worried about the additional cost when he mentioned it in passing. I fully expected Greg to hit me with an additional charge, so I was very pleasantly surprised when he said there would be no charge. He said he just wanted to make sure that it was done right. The home that we live in was built in 1955. When this house was built, there was only a ceiling fan for cooling. Window air conditioners were not as widespread and I would venture to say rare back then. Fast forward to central air conditioning, an open crawl space with water under the house and the high humidity and you have a recipe for disaster. From the crawl space under the house, moisture and depending on the season either hot, humid air or cold air was always affecting the climate control of the house. Consequently, we fought a never ending battle with mold and mildew in the closets and behind furniture.
After Crawl Space Doctors completed the crawl space under the house, we immediately noticed a decrease in humidity and the house not having a musty smell. Whether it is 89% or 25% humidity level outside, the humidity level inside the house with the air condition or heat has fluctuated near the 48% humidity mark +/- 5 points. While it will take a year to tell if I have an overall energy or cost savings, it appears that the air condition and/or heat are running less.
Finally, in my case I had to have a couple of concrete pillars put in because of a low spots due to wear of the last 59 years. To me it also says volumes when his employees said that they noticed a mold on the wood under the house because of the residual dampness. Rather than disregard the "small amount" of mold, and make a bad situation worse and fix it anyway, they cleaned the area yet again and rescheduled another time to get the work done. As I can't crawl under the house anymore, I may have never have known about the mold.
In short, I unequivocally recommended the Crawl Space Doctor and have given Greg explicit permission to use me as a reference in the future.
"It went very well. Boucon USA removed my original driveway, hauled off all of the spoils and poured my new driveway all in one day. Very professional and clean. I would be willing to hire them again for any concrete needs."
"I have used Cervantes Concrete several times in the past for concrete foundations, steps and sidewalks. Based on their past performances, They are my first call for concrete work and I have also already recommended them to others. Great customer service!"
Yes, you can cut up a box spring., but you’ll need to do so in layers. You can clear the fabric and fluff away to reveal the springs before removing them as well.
You should not do your own welding unless you have the proper training and experience. Most home electrical systems can only handle MIG welding, which creates weaker bonds than TIG welding and won’t work on certain metals or metal thicknesses. Both welding forms usually require the use of shielding gas, which can be dangerous to store at home. Additionally, welding machines create temperatures of over 3,000 degrees, and the sparks can blind you if you don’t have the proper equipment. As such, it’s usually better to hire a professional welder for your welding projects.
Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.
Costs depend on unit complexity, labor, wall mounting needs, and additional accessories like floating shelves.
Choosing the right metal fabricator for your project begins with research. Find a reputable fabrication company by searching for reputable contractors in your area, and then reviewing photos of their previous work, customer reviews, and photos of the company’s workshop.
Once you’ve narrowed down the list, contact the companies to ask about the types of metal fabrication projects they specialize and inquire about guarantees and warranties on workmanship. You should also ensure the company uses high-quality material, and ask about the schedule and turnaround time for your proposed project.
The Claxton, GA homeowners’ guide to concrete cutting services
From average costs to expert advice, get all the answers you need to get your job done.
