Get matched with top electricians in Arlington, GA

A C-wire is typically blue, but don’t rely on colors to find which wire is which when it comes to thermostat wires. The C-wire may also be black, brown, or purple. Instead, if you’re looking for the C-wire, look at the thermostat panel for a wire connecting to “terminal C,” or call in a pro to help you look for a C-wire.

The easiest way to determine the amperage of your electrical outlets is to check the corresponding breaker in your home’s breaker panel. The number is likely noted on the circuit breaker. If that fails, it’s possible to tell 15-amp and 20-amp outlets apart by looking at them. Fifteen-amp outlets have two vertical holes, while 20-amp outlets have one vertical hole and one T-shaped hole. 

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

If you find the power cables for your appliances are too short, there are ways to extend them for the cost of just the extra wiring you need. Simply cut and strip your wires, solder them together, and cover them using heat shrink tubing. Not everyone has a soldering tool on hand, so if you’re looking to extend in a pinch, an extension cord, power bar, or surge protector can do the job just fine.