Best chimney inspectors near Warren, CT

In most cases, it is best to leave icicles on your roof and allow them to melt naturally. You should only consider removing them if they are heavy enough to cause damage to your home or pose a risk to people below. Since removing icicles can be dangerous, it is recommended to hire a professional for the job if you have immediate concerns. To prevent the issue from recurring, you should address the underlying cause, such as improving your home's insulation or installing roof heating coils.

In most cases, yes, you should fix hail damage to your roof. For asphalt roofs that experience hail damage, the shingles can crack and tear from impact, potentially exposing the underlayment and other building material underneath to water and pests. You might save an average of $1,100 by neglecting repairs, but water damage can cost significantly more. Even on a metal roof, where penetration isn’t a concern, the dents hail can leave behind can detract from your curb appeal, potentially making your home less valuable.

Maybe you waited a little longer than you should have before dealing with the snow accumulation on your roof, and now you are wondering if there is risk of roof collapse. Here are some signs you should look out for: a sagging roof, cracking and cracking sounds, cracks in walls, and leaks in your attic and ceiling.

If you suspect potential roof collapse, do not delay. Take immediate action. Call a professional roofing company and get an inspection. You may want to move your belongings to a safe place and relocate your family until everything has been taken care of.

You shouldn’t put a new roof underlayment over an old one for a few reasons. Old felt must be removed in order to assess the condition of your roof decking, such as rotting wood or other structural issues. Also, if your roofer doesn't install a fresh layer of felt as is required by shingle manufacturers, your warranty may be voided. Finally, old underlayment removal is often included in the cost of roof repair or replacement, so there's no real benefit to leaving it on before installing a new layer.