Get matched with top insulation pros in Briggsdale, CO

Whether you should remove old insulation before blowing in new insulation depends on your particular situation. Fiberglass insulation attracts insects and mold over time, so if it has been decades since your last insulation upgrade, consider removing the old materials before placing the new ones. However, most types resist mold, insects, and mildew, so once you get the go-ahead from your contractor that your space is free from all three, feel free to install the new insulation directly on top of the pre-existing materials.

Ideally, you can add new insulation to your existing insulation. However, some circumstances require you to remove old insulation before adding any new insulation: 

• If the insulation is over 15 years old

• If the insulation is wet or moldy

• If it is vermiculite insulation

• If you see signs of pest infestation

Removing old insulation is best left to a pro who can safely dispose of potential moldy or asbestos-ridden insulation.

Yes, cold walls are a common indicator of poor or inadequate insulation, especially if the walls feel significantly colder than the air in the room. This suggests that heat from your furnace is escaping rather than being retained. The issue could be that the walls have no insulation, or that the existing insulation is old or has been damaged by water, moisture, or pests. Your best course of action is to hire a professional to investigate. An insulation contractor can determine if you need to add or replace insulation and can often perform the work without creating large holes in your drywall. If you suspect the problem might also be related to your heating system's performance, an HVAC technician can take a closer look.

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.