Top-rated insulation pros.

Get matched with top insulation pros in Fort Morgan, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your insulation service project in Fort Morgan, CO?

Select your specific project to find the pro for you.

Find Insulation pros in Fort Morgan

Avatar for J H Insulation
J H Insulation
5.0(
2
)
Blown-In Insulation - Install or UpgradeSpray Foam Insulation - Install

Serving Fort Morgan, CO and surrounding areas

Approved

In business since 2010

Free estimates

Emergency services offered

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business!

Artisia  NM  project
Artisia  NM  project
Fort Lupton  project
Fort Lupton  project
RV

+2

9 neighbors recently requested a quote
Avatar for Freeman Insulation and Construction Services
Freeman Insulation and Construction Services
4.2(
20
)
Batt, Rolled or Reflective Insulation - Install or UpgradeBlown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Fort Morgan, CO and surrounding areas

In business since 2017

Free estimates

Credit card accepted

"They responded immediately and the insulation was scheduled a few days later. They are really nice people and provide excellent service at a fair price. Carpet and floor were covered up for protection, and they cleaned and vacuumed everything after the job, even outside of the house. We first hired them to insulate the garage, and then decided to add extra insulation to the house attic. We are very happy with the job."
Stairs before soundproofing
Stairs after Soundproofing
Duct Wrap
Wrapping duct work
Walls and Ceiling

+3

Response time11 hrs
Recommended by93%of homeowners
Avatar for Spray Foam My Home
Spray Foam My Home
4.8(
35
)
Injection Insulation - InstallSpray Foam Insulation - Install

Serving Fort Morgan, CO and surrounding areas

In business since 2015

Free estimates

Credit card accepted

"I had used Community Insulation to add insulation to the attic and was so pleased with their professional service that I requested them to add insulation to the crawl space. I have recommended them several times."
FOAM
FOAM & BATTS
FOAM
FOAM
FOAM & CELLULOSE

+6

Response time3 hrs
Recommended by64%of homeowners
Showing 1-10 of 26
Insulation questions, answered by experts

While insulation is required for all exterior walls in a house, it is not typically required for interior walls. Local and state building codes mandate that new construction homes have adequate insulation in exterior walls and ceilings to suit the local climate.

However, there are several benefits to adding insulation to interior walls. It is excellent for sound-dampening between rooms and can help with temperature control by maintaining a regulated temperature in specific rooms and lowering heat transfer between adjacent areas. Insulating interior walls can also contribute to the overall energy efficiency of your home.

Yes, insulating hot water pipes helps your system run more efficiently. This is especially true in basements in colder climates, where cold air likes to settle in. There are a few ways to insulate water pipes (foam is common) to keep hot water hot, reducing the need for your water heater to constantly heat the water in the tank or your circulator to kick on more than necessary.

Yes, you need a 1.5-inch to 2-inch air gap in a cathedral ceiling to allow proper air flow and prevent cathedral ceiling venting problems. This amount of airspace allows warm, moist air to properly leave your ceiling to avoid moisture build-up and other issues that put your home at risk. You can also add an air vent for extra air flow.

Unless your cellulose insulation is wet, moldy, or showing signs of mildew or pests, there’s no need to remove it before adding new insulation on top of it. Inspect your insulation thoroughly before adding the new insulation, and if you’re unsure how to assess the presence of mold or mildew, talk to a mold remediation specialist near you.

Unfaced wall insulation is easier to cut and install, making it the better choice for a DIY project. It’s also more affordable. But if it’s unfaced, you’ll likely need to add a vapor barrier to reach your desired R-value and efficiency, as it doesn’t offer any moisture barrier.

Faced insulation uses paper or foil to create a built-in barrier and doesn’t require an extra step. It’s also more fire-resistant and safe. But it’s quite a bit more expensive and a little bit harder to work with as a DIYer.

The Fort Morgan, CO homeowners’ guide to insulation services

From average costs to expert advice, get all the answers you need to get your job done.