Top-rated deck repair pros.

Get matched with top deck repair pros in Traver, CA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck repair project in Traver, CA?

Select your specific project to find the pro for you.

Find Deck repair pros in Traver

Avatar for Clear Horizon Home Solutions, Inc.
Clear Horizon Home Solutions, Inc.
4.3(
214
)
Deck or Porch - Repair

Serving Traver, CA and surrounding areas

In business since 2011

Free estimates

Credit card accepted

"Demo-ed and replaced an exterior deck (approx 350 sq ft). The owner and his crew were simply outstanding in estimating, executing, cleaning-up aspects of this job. One is hard-put to assemble adequate adjectives to describe the quality of his work and the pleasure the whole family has experienced from his exceptional work and attitude. Bravo!"
1
2
3
Kitchen Remodels
2

+2

Recommended by82%of homeowners
Ceasar Briones Construction
4.3(
3
)
Deck or Porch - RepairDeck or Porch - Repair - For Business

Serving Traver, CA and surrounding areas

In business since 2009

Credit card accepted

"When I discovered that I had a major problem with my house and that it was in jeopardy of collapsing, I had to act quickly to get temporary shoring in place and also get a structural engineer and architect on board to get the designs moving.  I met Ceaser Briones, of Briones Construction, and walked him through the requirement to shore up the ceiling to prevent the house from collapsing.  Briones Construction jumped in and went to work immediately and helped me save my house.  They didn't take advantage of my situation by trying to overcharge me.  I know because I build facilities and maintain them for a living, and know how much it should cost to do the work.
Once all of the shoring was in place, we focused on the structural and architectural designs to make the necessary structural repairs and to remodel the house.  Briones Construction was instrumental in helping the architect and structural engineer with field measurements and confirming as-built conditions.  Once the designs were finished and permits pulled, Briones Construction didn't hesitate a moment to get started with the work.  They coordinated every aspect of the job, including moving my furniture, fencing the site, bringing in a roll off trash bin, etc.   They knew what they were doing and were very professional.  Briones Construction's work was meticulous and every detail was addressed.  Their quality was outstanding in every respect."
Recommended by100%of homeowners
Showing 1-10 of 19
Deck Repair questions, answered by experts

Yes, an elevated deck can increase a home's resale value. Homeowners can expect a 65% return on investment from the cost of a second-story deck installation. For example, if you spend $5,000 to install a second-story deck, that deck will add $3,250 to the value of your home.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

Footings for ground-level decks need to be at least 12 inches deep, and some areas require them to be even deeper. A standard range for deck footings is anywhere from 12 to 48 inches. The minimum footing depth is determined by an area’s frost line and soil conditions. If you’re unsure how deep to install deck footings, check local building codes to find the minimum footing depth in your area. 

When staining a deck, don’t skip surface prep, avoid staining damp or dirty boards, and don’t apply stain in extreme heat, cold, or wet conditions. Never overload the wood with a stain, as too much can cause tackiness or peeling. Also, don’t forget to test a small area first to ensure the color and finish look right.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

The Traver, CA homeowners’ guide to deck repair services

From average costs to expert advice, get all the answers you need to get your job done.