Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Traver, CA

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Traver, CA?

Select your specific project to find the pro for you.

TRUSTED BY TRAVER, CA HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon38
    Verified deck cleaning services reviews

Find Deck cleaning pros in Traver

Avatar for Top Flight Fixology
Top Flight Fixology
4.5(
56
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Traver, CA and surrounding areas

In business since 2019

Free estimates

Emergency services offered

"Daniel is meticulous. He is professional, courteous, and friendly. He’s good at communicating his estimated arrival times, so I always knew when to expect him. He did a beautiful job installing the new doors, and cleaned up afterward. He also installed a set of shelves in the upstairs master bedroom. Daniel can do anything. I highly recommend him."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+70

Recommended by92%of homeowners
Ceasar Briones Construction
4.3(
3
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Traver, CA and surrounding areas

In business since 2009

Credit card accepted

"When I discovered that I had a major problem with my house and that it was in jeopardy of collapsing, I had to act quickly to get temporary shoring in place and also get a structural engineer and architect on board to get the designs moving.  I met Ceaser Briones, of Briones Construction, and walked him through the requirement to shore up the ceiling to prevent the house from collapsing.  Briones Construction jumped in and went to work immediately and helped me save my house.  They didn't take advantage of my situation by trying to overcharge me.  I know because I build facilities and maintain them for a living, and know how much it should cost to do the work.
Once all of the shoring was in place, we focused on the structural and architectural designs to make the necessary structural repairs and to remodel the house.  Briones Construction was instrumental in helping the architect and structural engineer with field measurements and confirming as-built conditions.  Once the designs were finished and permits pulled, Briones Construction didn't hesitate a moment to get started with the work.  They coordinated every aspect of the job, including moving my furniture, fencing the site, bringing in a roll off trash bin, etc.   They knew what they were doing and were very professional.  Briones Construction's work was meticulous and every detail was addressed.  Their quality was outstanding in every respect."
Recommended by100%of homeowners
Deck Cleaning questions, answered by experts

Yes, deck pier blocks can be used as an alternative to traditional deck footings, particularly for small or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks don’t require digging or pouring. However, their use is regulated by local building codes, and they may not be permitted in areas prone to high winds, earthquakes, or hurricanes. Always consult your local building codes before choosing them for your deck project.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

Yes, Ipe is more expensive than Trex decking—both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while Trex decking costs $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you’ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.

Coping is the material that lines the perimeter of a pool and seals the transition between the top of the pool wall and the water. Decking surrounds the poolscape and extends far beyond the water's edge to provide a safe walking and lounging area. In short, coping is the border between the decking and the pool itself.

That depends on the condition of your deck. An older deck that looks drab, worn, or has multiple damaged boards might be worth replacing before selling. However, if your deck is in good condition, you can simply clean, repaint, or stain it.

The Traver, CA homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.