Get matched with top pool and spa technicians in Taft, CA

Most hot tubs use between 1,500 watts and 6,000 watts of electricity, depending on the voltage of your heater. 120-volt heaters tip toward the low end, and 240-volt heaters tip toward the high end. Expect your pump to add another 1,500 watts. Newer, energy-efficient models use less electricity, while older models use more.

How often you change the water in your swim spa depends on how often you use it. Most manufacturers recommend changing the water every three to six months. If you use your swim spa throughout the seasons, it’s a good idea to set up a quarterly deep cleaning schedule. The ideal instructions should be in the owner’s manual.

Most hot tubs will experience leaks due to wear and tear in the plumbing or the shell itself. The second most common issue is a heater malfunction due to the ongoing heat stress on moving parts. Finally, clogs happen in hot tub jets, especially when it’s time to change the filter.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.