Get matched with top pool and spa technicians in Lamont, CA

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

To refill a hot tub after winter, start by opening up the tub and giving it a quick cleaning. If you use antifreeze, drain out the water then grab a hose and thoroughly clean the tub shell out, spraying water into each jet of the tub. 

Reconnect the hot tub and turn the power back on. When it’s time to fill the tub again, insert the hose into the filter well (if available). Avoid trapping too much air in the water lines, which can cause the pump to lock up when it starts again. Add the necessary chemicals and start the heating process. It will take some time—most of a full day—for the water to heat up again.

Follow these general safety tips for spas and hot tubs:

• Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

• Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

• Don’t use the hot tub or your pool during a thunderstorm. 

• Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

When your hot tub is not in use, you can keep it at a constant soaking temperature of around 100 degrees Fahrenheit. For extended periods of non-use, you can lower the temperature by about five degrees. This slight decrease makes it easier and quicker to heat back up to a desirable level when you're ready to use it again. Additionally, you might consider lowering the temperature by a couple of degrees during the summer to avoid feeling overheated.