Best countertop and backsplash pros near Sebastopol, CA

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

While epoxy resin is generally durable, it is not scratch-proof. Some sources state it is highly resistant to scratches from minor sources, while others note it can scratch and chip easily from sharper or heavier items. To prevent damage, always use a cutting board and avoid sliding heavy or rough-bottomed objects across the surface. If a scratch does occur, be aware that epoxy can be difficult to repair by sanding, often requiring an orbital sander for effective results.

Onyx countertops have pros and cons. If you seal it properly and take care not to damage it, it can make a good countertop surface. However, it's more often used in bathrooms, where it’s less likely to sustain damage. Having an onyx kitchen countertop is possible, but you’ll need to take extra care not to burn, stain, or otherwise damage the material.

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.