Get matched with top doorbell installation pros in Palmdale, CA

Insulating windows with plastic works, but it can be time-consuming, and the end results can—and often do—end up lacking in aesthetics. Window film and caulking your windows to make sure there are no drafts are two options that increase the energy efficiency of your home in a low-cost way. Plastic can be a good strategy while you consider alternatives.

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.

If you plan on heating your garage, you must install a vapor barrier when drywalling the garage. A vapor barrier protects your garage from frost and mold that can occur through condensation. If your garage is unheated, you don't need to install a vapor barrier. The only exception is if you regularly crank the heat in your car before getting in it. In this case, you may still want to install a vapor barrier, as your car can heat your garage.

Vapor barriers in attics are a bit outdated and most areas no longer recommend them for attic spaces. For vented attics, the best method is usually to install drywall and cover it with latex paint before attaching insulation fiberglass, cellulose, or foam insulation. When renovating an attic to use as a living space, a contractor can guide you on the best way to cover insulation.