Get matched with top dishwasher installation pros in Monte Sereno, CA

There are some dishwasher care tips to extend its longevity and keep your dishes sparkling. Not overloading your dishwasher is key to letting water and soap move freely through the unit. Too much soap can stress your dishwasher unnecessarily, causing it to break down sooner. 

Cleaning your dishwasher is essential for its performance, so every three to six months, put two cups of white vinegar in a dishwasher-safe cup on the top rack and run a complete cycle. When done, place ¼ cup of baking soda inside and run a short cycle to eliminate any lingering odors.

To get rid of standing water in your dishwasher, first try activating the drain mechanism by pressing and holding the cancel button for at least three seconds. If that doesn’t work, you’ll need to do some troubleshooting to drain the standing water from the dishwasher. This will involve shutting off the power, then scooping out the water, cleaning the drain filter, and clearing the air gap. You’ll also want to run the garbage disposal and check the drain hose for clogs.

Your dishwasher drains through a hose that attaches to the plumbing below your sink or snakes out the back of your machine. In most cases, you can access one side of the hose from below your sink, as it usually ties into the same drainline that your sink uses. Otherwise, you may need to pull the dishwasher out of the counter to access it.

Several signs can tip you off to a clogged dishwasher drain. At first, you may notice that it’s taking longer than usual for the dishwasher to drain, or you may hear gurgling sounds during the draining part of the cycle. You might also notice water backing up into your sink or excess food at the bottom of the dishwasher after a load. The most obvious sign, though, is seeing standing water at the bottom of your dishwasher after the cycle has finished.