Get matched with top bathtub restoration pros in Livingston, CA

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

Refinishing reduces landfill waste, minimizes resource extraction impacts, and uses fewer raw materials than new installations.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.