Get matched with top ceramic tile pros in Fort Jones, CA

Porcelain is a relatively affordable, mid-range countertop material. It typically costs between $50 to $70 per square foot.

Compared to quartz, porcelain is slightly more affordable, as quartz generally ranges from $50 to $200 per square foot. However, lower-quality, builder's grade quartz can be similar in price to porcelain.

Compared to granite, the price can be similar, depending on the quality of the stone. While granite slabs can range from $50 to $200 per square foot, you can find lower-end granite in the same price range as porcelain. High-end granites will cost significantly more.

Porcelain is generally more expensive than laminate, acrylic, and ceramic, but less expensive than high-end slate, concrete, and marble. A key benefit is that porcelain does not require sealing, which reduces long-term maintenance costs.

The tile spacing you should use will depend on the tile and where you’re installing it. Choosing the right tile spacers to maintain a consistent gap between your tiles is tricky. Generally, tile spacing shouldn’t be less than 2 millimeters on walls and 3 millimeters on floors because of stress relief requirements. Getting it wrong can result in uneven tiles and early repairs.

To ensure an even and unbending surface to lay tiles on, you’ll typically need to put a subfloor under a tile floor. Fiber cement backboards are the most common choice, but using plywood is also possible. Don’t neglect this step, or you could risk water damage and grout or tiles prematurely cracking or crumbling, especially in an area with high foot traffic. 

No, you don’t need to remove the old grout before installing new tile over existing tile. In fact, the old grout helps fill in gaps between tiles, creating a more even surface for the new layer. However, it's important to ensure that the grout is clean, solid, and free of cracks or crumbling areas. Damaged grout should be repaired or replaced before proceeding. Cleaning the surface thoroughly and filling any low spots will help the new adhesive bond properly and ensure a smooth, stable installation.