Get matched with top well and pump technicians in Cutten, CA

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

The costs depend on whether you are buying into an existing well or starting from scratch. The average well drilling cost is between $25 and $60 per foot. The average cost to repair a well is between $350 and $1500. If you have a shared agreement and a community association, there will be additional legal and administrative fees. 

The average lifespan of a deep well pump is between 15 and 25 years, after which you’ll have to replace it. Several factors can affect the lifespan of a well pump, such as the quality of the unit. Proper maintenance and repair can also help extend your well pump’s lifespan as well as keep adequate water flow and pressure throughout your home.

There are a few signs you can look out for to determine if your well pump needs to be repaired or replaced, including the following:

• Your water pressure fluctuates.

• You lose water entirely on occasion.

• You notice the pump making unusual noises.

• Water sputters out of your fixtures.

• Your utility bills suddenly spike without explanation.

• You notice sediment or cloudiness in your water.

• You hear that the pump runs continuously.

If you notice any of these issues, call a professional well pump repair service to inspect it and determine whether you should repair or replace it.