Get matched with top dishwasher installation pros in Costa Mesa, CA

If the dishwasher is in working condition, start and run a complete cycle with nothing inside. Let it drain and sit overnight before removing the hoses. In theory, it should effectively drain. You may find residual water in the hoses, but you can plug them. If the dishwasher breaks down midcycle it can sometimes be full of water. You’ll need to manually remove the water with a plastic cup before removing the dishwasher.

To create a siphon break and remove any chance of dirty sink water or water that backs up into the sink from getting into your dishwasher, your dishwasher drain hose needs to have a high loop or an air gap device as part of its installation. All building codes require at least a high loop. In many places, it’s necessary to install an air gap device to meet the code.

You should follow the instructions listed on the detergent packaging and in your dishwasher user manual. Often, this means inserting the tablet or pod into the detergent dispenser (and not in the bottom of the dishwasher). If you put the pod anywhere else, it might dissolve too early in the cycle and fail to clean your dishes properly.

Your dishwasher drains through a hose that attaches to the plumbing below your sink or snakes out the back of your machine. In most cases, you can access one side of the hose from below your sink, as it usually ties into the same drainline that your sink uses. Otherwise, you may need to pull the dishwasher out of the counter to access it.