Get matched with top toilet pros in Coachella, CA

Emergency plumbers charge a significantly higher rate than for standard service, typically 1.5 to 3 times the normal hourly cost. You can expect to pay between $100 and $500 per hour, with an average of around $200 per hour. In addition to the higher hourly rate, many plumbers charge a flat emergency service or trip fee, which can be between $150 and $300. The final cost depends on the timing of the call; prices are highest for major holidays, followed by weekends and after-hours service on weekdays. For a complex job on a major holiday, a master plumber's rate could reach as high as $600 per hour.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If you notice water coming out of the bottom of your tank or the flush handle, you obviously have a leaking tank. Water on the side of the tank can indicate cracks. Other signs include the toilet running and flushing without anyone touching the handle, needing to jiggle the handle to make the water stop after flushing, or needing to hold the handle down to empty the water tank.

If you’ve accessed the bolts and nuts that hold your toilet seat in place and can’t unscrew them, it’s possible that they were overtightened or that the material corroded over time, making it impossible to unscrew. If that’s the case, you can either call in a plumber for help, or you can DIY a solution if you’re careful. Lay down masking tape around the mounting bracket and then use the tape as a surface to lay a hack saw blade. Move slowly to cut through the bracket and bolt, being careful not to damage the porcelain in the process.