Get matched with top pressure washers in Applegate, CA

While power washing isn't a requirement before you stain a fence, it can make the job much easier and faster while reducing manual labor requirements. The stain will not work if the wood is full of dirt and dust, so power washing, sometimes called pressure washing, is a fast and effective way to prepare the wood for staining. Remember that you need to stain or repaint relatively soon after the wood has dried so that there isn’t time for dust and dirt to build up again. 

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

Yes, you can use a pressure washer to effectively clean debris, dirt, and grime from your gutters, but it must be done with caution to avoid damage. Always use a low-pressure setting, with a recommended range between 1,200 and 1,800 PSI. Excessive pressure can bend or dent aluminum gutters, damage seams, peel paint, or even knock shingles off your roof, potentially leading to leaks and moisture issues. For a safer alternative, consider soft washing or cleaning them by hand. When using a pressure washer, it is safer to use gutter elbow extensions from the ground rather than climbing a ladder, as the force can cause instability. Due to the risks, you may want to hire a licensed and insured contractor for the job.

Brick takes longer to dry than less porous materials like concrete. If you are waiting to spot clean, a full day of mild weather should do the trick. If you are waiting to paint or apply a finish or sealant, give it three to four days to ensure the brick is absolutely dry as a bone. You don’t want any residual moisture whatsoever before laying down paint or sealant.