Top-rated drywall pros.

Get matched with top drywall pros in Charleston, AR

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Charleston, AR?

Select your specific project to find the pro for you.

Find Drywall pros in Charleston

Avatar for Country's Fixin & Windows
Country's Fixin & Windows
5.0(
23
)
Drywall - Repair

Serving Charleston, AR and surrounding areas

In business since 2024

Free estimates

Offers commercial services

"These guys did an absolute amazing job repaired a hole in ceiling and treated the water stain. Repainted whole kitchen ceiling. Perfect can’t even tell hole was there. They are also coming back to replace a broken window for me. HIGHLY recommended them. Price was on point thanks again for the amazing job"
Sunroom
Sunroom
Sunroom
Sunroom
Sunroom

+1

Response time2 days
Response rate94%
Recommended by4%of homeowners
Avatar for Pristine Home Solutions LLC
Pristine Home Solutions LLC
5.0(
8
)
Drywall - Repair

Serving Charleston, AR and surrounding areas

In business since 2025

Credit card accepted

"The work was quick and amazing, Josh and his helper were very kind and professional! They were hired to paint my living room walls and ceiling and they were able to finish in 2 days. Would definitely recommend their work! 10/10"
Epoxy coatings
Epoxy coatings
Epoxy coatings
Epoxy coatings
Epoxy coatings

+92

Response time2 hrs
Response rate100%
...
Showing 1-10 of 101
Drywall questions, answered by experts

While it’s most common to sand plaster dry, it is possible to wet-sand plaster, too. Doing so can reduce the amount of plaster dust released into the air and make it easier to work in smaller, more delicate areas (such as around wall trim). However, some people find that wet sanding leads to more imperfections, which is why larger walls are more often dry sanded to ensure an even finish.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Choose a drill bit that is the size of the screws of the anchors you will use. You aren’t drilling through metal or concrete—hopefully—so any standard twist, wooden or all-purpose drill bit will work fine. It’s also important to have a screwdriver capable of drilling through the drywall and into the stud. The good news is most available drills, even the older ones, can do this with no issue.

When sanding drywall mud, you’re going to create a very fine dust that may contain silica. Silica dust contains crystalline silica, which can cause long-term illnesses for people who inhale it in significant quantities. Wear a mask while sanding drywall. Then dampen a drywall sponge to wipe the dust off the drywall, helping to reduce the amount of dust that may become airborne.

Some textures are easier than others to DIY, but the short answer is yes, you can absolutely texture walls yourself. You’ll need certain materials, like a trowel or paint sprayer, but the most important things you’ll need are patience and time. DIYing wall texture can save money and be a fun, messy project, but homeowners need to know that adding texture to a wall isn’t a quick project. 

The Charleston, AR homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.