Get matched with top garage pros in Warrior, AL

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

You don’t need a garage door opener unless you need or desire the convenience they offer. While you may be able to open some garage doors manually, having a garage door opener makes life a lot easier. There is an exception, though—a motorized opener is an absolute must if you have a two-car garage (or larger), as the door will be too heavy for the average person to lift on their own.

It’s possible to use a torch to melt ice on your garage door, but we don’t recommend it. It’s very easy to bring the flame too close to the door, which can melt the weather stripping or even the garage door itself. You’ll melt ice quickly with a torch, but the damage you’re likely to cause can end up costing you a few hundred dollars to fix, which isn’t worth it. Instead, we recommend pouring hot water over the frozen area or using a less intense heat source, like a hair dryer or space heater.

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.