Get matched with top garage pros in Alpine, WY

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

Most cabinetry made for a garage will have special coatings and finishes built to withstand extreme heat and cold, moisture, pest damage, rusting, and dry rot. However, many homeowners have put their old kitchen cabinets in the garage, added a couple of fresh coats of paint, and use them for a while without too much wear and tear.

Getting a garage door tune-up is worth it. Tune-ups are a form of preventative maintenance that help extend a garage door's lifespan and prevent dangerous issues, like worn springs or misaligned sensors. The cost to get a garage tune-up is far less than letting problems get out of hand and causing costly repairs—or worse—injuries.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.