Get matched with top electricians in Gassaway, WV

To upgrade electrical systems in older homes, you might need to reroute new wires with lath and plaster walls. That’s because it’s more challenging to get inside the walls of an older home compared to a modern home, which usually uses drywall. But there are easier ways to level up your electrical game in an older home. For instance, you can swap out an old furnace for a new electric heat pump, or you could use a heat pump for water heating.

Track lighting typically needs to be hardwired, connecting directly to the electrical wiring in your ceiling for a permanent and reliable power source. Hardwiring provides a clean and professional look with no visible cords. However, plug-in track lighting options can be connected to a standard electrical outlet, offering easier installation and flexibility. The choice between hardwired and plug-in track lighting depends on your needs, preferences, and existing electrical setup.

It can be safe to buy or live in a house with knob and tube (K&T) wiring, but only if the system is in good condition, functional, and has been thoroughly inspected and approved by a licensed electrician. Never purchase a home with K&T wiring without getting a professional electrical inspection first.

Key considerations include:

• Safety and Condition: An inspector will verify that the wiring is safe and has not deteriorated. Over time, the insulation can wear away, leaving exposed wires that pose a significant fire or shock hazard.

• System Capacity: The electrical service should be at least 60 amps. However, even at this capacity, K&T systems often struggle to handle the demands of modern appliances and electronics.

• Lack of Grounding: Knob and tube wiring is an ungrounded system, which is a safety concern for many modern devices.

• Ongoing Maintenance: If you live in a home with K&T wiring, it's recommended to have it inspected by an electrician every one to two years to ensure it remains in safe working order.

Ultimately, any inspection or modification of a knob and tube system should always be performed by a certified professional.

If only half of your outlet works, there are usually two possible causes: faulty wiring or a half-hot outlet. The first thing you'll want to do is check the circuit breaker panel to ensure that it's not tripped. If your circuit breaker isn't tripped, turn off the electricity and inspect the wiring to see if anything has come loose or corroded. 

If you have a half-hot outlet, it means half of the outlet is controlled by a switch somewhere on the same circuit, which should be nearby. This is an intentional electrical design commonly found in rooms without overhead lights.