Top-rated drywall pros.

Get matched with top drywall pros in Wrightstown, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Wrightstown, WI?

Select your specific project to find the pro for you.

TRUSTED BY WRIGHTSTOWN, WI HOMEOWNERS

  • Average homeowner rating star icon5
    Average homeowner rating
  • Verified reviews icon17
    Verified drywall services reviews

Find Drywall pros in Wrightstown

Avatar for Wayne's Plastering, LLC
Wayne's Plastering, LLC
5.0(
1
)

Serving Wrightstown, WI and surrounding areas

Approved

In business since 2022

Free estimates

Small jobs welcome

"Kasey with Wayne's Plastering did quality work and quickly as well. He handled some drywall install, repair and is a plaster-master! I highly recommend his work!"
Response time3 days
12 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for Desert Discard Junk Removal and Hauling LLC
Desert Discard Junk Removal and Hauling LLC
4.9(
7
)

Serving Wrightstown, WI and surrounding areas

Free estimates

Emergency services offered

Credit card accepted

"Fantastic service and transparency! I’m always weary about hiring new contractors but Mark and his team made us feel so comfortable during the whole project especially with everything we needed done. Can’t thank them enough and would 10/10 recommend!"
Ropson Residence
Ropson Residence
Ropson Residence
Ropson Residence
Additional Photos

+16

Recommended by100%of homeowners
Avatar for Sullivan Exteriors
Sullivan Exteriors
4.7(
44
)

Serving Wrightstown, WI and surrounding areas

In business since 2008

Free estimates

"Called Ben and asked if he could replace the shingles that were damaged from removing Satellite dish's that were on the roof. he came when he said he would and was early did a great job on replacing the shingles and cleaned up everything. I would highly recommend Ben and his company for any work that needs to be done on your house.
"
Recommended by95%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)

Serving Wrightstown, WI and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Showing 1-10 of 26
Drywall questions, answered by experts

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

The time it takes for thinset to dry is determined by your room’s ambient temperature and humidity levels. Assuming the average humidity level is around 40% with an average temperature of 70 degrees Fahrenheit, thinset can dry within 48 hours. Lower temperatures and higher humidity can extend the curing process beyond 72 hours, while high heat and zero humidity can shorten the curing process. However, thinset can crack if it dries too fast.

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.

Yes, if there is mold in your drywall mud and you then use it to build walls in your house—or if mold develops in your set drywall, like it can in hot and humid areas—it can lead to illness. Mold in your drywall (or other parts of your home) can make existing respiratory conditions or allergies worse, and the effect can be more intense for those who have existing health issues or compromised immune systems.

Yes, you can mount a TV on plaster walls—as long as you attach it to the studs. Alternatively, you can use toggle bolts, molly bolts, or another type of hardware that’s strong enough to support a TV. 

If you aren’t comfortable with this type of project, you can hire a pro. The cost of mounting a TV to a plaster wall ranges from $25 to $600 (or more), depending on the TV’s weight, size, and other factors.

The Wrightstown, WI homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"