Top-rated pool and spa technicians.

Get matched with top pool and spa technicians in Phillips, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Phillips, WI?

Select your specific project to find the pro for you.

Find Pool and spa technicians in Phillips

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Phillips, WI and surrounding areas

In business since 1971

Credit card accepted

"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Pool and Spa Servicing questions, answered by experts

Most hot tub motors can last between five and 10 years; however, hot tub motors can burn out sooner if the hot tub water is not maintained or if the motors themselves are not maintained or protected from the elements. Since hot tub motors (also referred to as spa pumps) power the jets and circulate the water, they are important for the functioning of your spa. Buying a quality motor, keeping the hot tub filter clean, and keeping the wet end of the motor wet and the dry end dry can help them last longer.

Follow these general safety tips for spas and hot tubs:

  • Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

  • Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

  • Don’t use the hot tub or your pool during a thunderstorm. 

  • Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

Many people find saltwater tubs worth the upfront expense. They cost less to maintain than traditional hot tubs, so you can save in the long term. Maintenance is also easier, typically involving balancing the pH and cleaning the tub rather than adding chemicals. They’re also gentler on sensitive skin, and you won’t walk away with a strong chlorine odor.

If water is left inside the hot tub pump over a cold winter, it could freeze and severely damage the pump, water lines, and jets. That can cause leaks, which require very expensive repairs. Freezing or leftover water can stain and damage the hot tub shell, which leads to replacement. Even in mild climates, leaving sitting water in the tub or pipes for a long period of unuse is a bad idea, since disinfecting chemicals fade and the water can develop bacteria, algae, and other big headaches when it’s time to use the tub again.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

The Phillips, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.