Top-rated pool and spa technicians.

Best pool and spa technicians near Boulder Junction, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Boulder Junction, WI?

Select your specific project to find the pro for you.

Top-Rated Pool and spa technicians in Boulder Junction - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Boulder Junction, WI and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Pool and Spa Servicing FAQs, answered by experts

Yes, hot tubs can use a significant amount of electricity, primarily to keep the water heated. A typical hot tub uses between 1,500 and 6,000 watts, and the pump can add another 1,500 watts. This usage can result in a monthly cost of around $20 to $30. The exact amount of electricity consumed depends on several factors, including the hot tub's age, size, heater voltage (120V vs. 240V), usage habits, and thermostat setting. Newer, energy-efficient models generally use less power than older ones. To reduce electricity costs, consider investing in an energy-efficient model, using a quality insulated cover with a thermal blanket, and keeping the filters clean.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

It’s easy to keep your hot tub clean and safe for all to enjoy by following a few simple tips:

  • Make sure anyone who uses the hot tub rinses themselves and their swimsuits off, perhaps in an outdoor shower near the hot tub. 

  • Don’t add anything to your hot tub’s water. Bath oils and bubble bath liquids might seem like a fun addition to your hot tub experience, but these substances will turn the water in your tub foamy and its surfaces hard to clean. 

  • Restrict eating in the tub to light snacks that you can easily clean out if there’s any spillage. Crumbs from crackers and chips can be difficult to pick up. 

  • Make it a no-pet zone. Pet fur and dander can pose a cleaning issue, but it’s also not a great idea for your pet’s health and safety. 

Follow these general safety tips for spas and hot tubs:

  • Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

  • Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

  • Don’t use the hot tub or your pool during a thunderstorm. 

  • Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

For a fully-foamed hot tub, freezing typically occurs when the temperature drops below 28 degrees Fahrenheit and remains at or below this level continuously for a minimum of 36 hours. If your hot tub and pumps are still operational, however, the water circulates, and this continuous movement helps prevent freezing, even in very cold conditions. This circulation, along with the insulation provided by the foam, helps maintain the water temperature and prevent it from freezing during extended cold periods. Still, if you’re not planning to run it regularly, be sure to winterize the hot tub properly to prevent damage from freezing.

The Boulder Junction, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.