"Very prefessional and thorough. Left my place clean after the install, and even loaned me some goo-be-gone from their toolbox for a project that I was working on while they were installing my furnace. They reviewed what they did at the end, and gave me a card so that I could call with any issues. Would highly recommend Sears and their contractors."
"Jim is local. It went great. Jim Ferrell is a professional of the highest caliber. Responded quickly, took care of my problems, and advised me as to better means of protection than I had. He came back a second time to uninstall software that I purchased that did not provide adequate protections and installed free software that would do the job. He did the work through remote connection, but is available on site if necessary. For those people needing help on getting red of malware, viruses , etc. on your computer, Jim is local, better than all thse remote out of state location providers, is a mature, highly trained professional in this area. If you go to local computer stores you get very young people that can do a basic job, but are no where near the professional level of Jim. I highly recommend Jim to anyone that needs these type services. "
"AHS is ok. They cover repairs of most everything under the roof of your house. The companies that contract with them are not always the best. You call AHS with the issue, they send a fax to the repair company and give you the contact info. If they don't contact you within 24 hours, you call them. Sometimes they answer, sometimes they don't. When they arrive (usually three days or so later), they service the item. if it has issues within the 90 days, you call AHS again, they are sent out with no charge. If the serviceman decides the unit is unrepairable, AHS will allow you to choose a replacement from their listing (usually not as good as what you have) they will install and remove your old item, or give you wholesale amount to buy and install your own. Prices vary on what you want covered and what you want the copay to be, plus where you live. For me it is 49.99 per month with a 75.00 time of service order. You can have more than one item serviced at the same time under the same fee. If you have a SEAR product the repair guys are great. Not that wild about the other ones they send out. But it is a big savings compared to calling someone on your own. The cost of service is only the 75.00 copay."
"We just hired him for a furnace checkup. We thought the service was one price, but he charged us more to replace the filter because ours was the larger filter then standard. He had to reschedule our first appointment, but that wasn't a problem for us."
"Installers were extremely professional and courteous. It took 3 days instead of two days, however, before leaving each day installers cleaned any mess they made. Before leaving the last day they made sure the system worked without any problems and explained the remote control and the cleaning of the filters."
Mischo Mechanical has one mission- to serve all your plumbing needs! We have been helping consumers like yourself since 2002. We offer professional installation and repair on all your plumbing needs. Mischo Mechanical is a family owned and operated business. We take great pride in dealing personally with all of our customers. With our low overhead, we can afford to provide a face-to-face experience that will set us apart from any other plumbing companies. We take pride in serving our customers as people not as numbers. We believe in making our customers repeat customers. Most of our business comes directly from references by previously satisfied customers. We are confident that every job produced by Mischo Mechanical LLC will meet and exceed all customer expectations. Whether you are installing new plumbing or repairing existing plumbing, we have the qualifications to give you professional and quality work that is comprehensive and complete. That is our promise to you. Thank you for your time and consideration, we look forward to helping you meet all your plumbing needs!
Hydronic and standard electric baseboard heaters differ in how they operate, their cost, and their performance. Standard convection heaters use electric coils to heat the air directly, while hydronic heaters warm a contained liquid like water or oil, which then radiates heat into the room.
In terms of cost and efficiency, hydronic heaters usually have a higher upfront price but are more energy-efficient and cheaper to run over time. This is because the heated liquid retains warmth, allowing the heater to continue providing heat for a while after the thermostat turns it off. In contrast, electric heaters provide heat more quickly but are less efficient.
Ultimately, the better choice depends on your priorities. If you need a room to heat up fast and have a lower initial budget, an electric heater might be suitable. If long-term energy savings are more important and you don't mind a slower heat-up time, a hydronic heater is likely the better option.
The cost-efficiency of baseboard heaters depends on the type and how you use them. Generally, standard electric baseboard heaters can be expensive to run because they use electric resistance heating, which is less energy-efficient than systems like forced-air or heat pumps. However, hydronic and gas versions are typically much cheaper to operate. Hydronic models are more energy-efficient because they heat a liquid that retains warmth longer, preventing the thermostat from turning on and off as often. The overall running cost is also influenced by local electricity rates, your home's insulation, and your usage habits. To increase efficiency, you can use baseboard heaters for zoning, meaning you only heat the specific rooms you are using.
Boilers are equipped with multiple safety features to ensure safe operation. These include pressure relief valves to prevent overpressure, temperature high-limit switches to avoid overheating, and flame failure safety devices in gas boilers to cut off the gas supply if the flame goes out unexpectedly. Low water cutoffs prevent operation with insufficient water levels, and pressure gauges help monitor pressure levels. Ventilation and flue systems prevent the buildup of harmful gasses. Boilers often feature error code systems for automatic shutdown during malfunctions and gas leak detection for safety. Regular maintenance is crucial to ensure these safety features function correctly.
There are several types of home radiators, and the most common are steam heat radiators, electric radiators, and dual-fuel radiators. Steam heat radiators are connected to a boiler. Electric radiators can operate without being connected to anything else—they just need an electrical outlet. If you have a dual-fuel radiator, you’ll see a valve at the bottom of the system with a wire coming out of it and going into a wall. These are often your towel radiators in the bathroom. The type of radiator you have will impact how you turn it on.
While you’ll pay more upfront for a brand-new HVAC unit, you can save money in the long run. Here’s how to save on your new HVAC system:
When purchasing a high-efficiency system, your energy bills will be lower in the future.
You may be eligible for special offers from your local energy company.
Depending on the system, you may be eligible for HVAC rebates and tax credits.
Choose to replace your air conditioning unit and furnace simultaneously to save on labor and installation costs.
The Kohler, WI homeowners’ guide to boiler installation services
From average costs to expert advice, get all the answers you need to get your job done.
Discover the average electric boiler installation cost, key price factors, and ways to save. Get transparent, expert-backed estimates for your project.
