Top-rated floor polishers.

Get matched with top floor polishers in Gordon, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Gordon, WI?

Select your specific project to find the pro for you.

Verified Reviews for Floor Polishing pros in Gordon, WI

*The Angi rating for Floor Polishing companies in Gordon, WI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Floor Polishing needs.

*The HomeAdvisor rating for Floor Polishing companies in Gordon, WI is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Floor Polishing needs.

Last update on October 17, 2024

Find Floor polishers in Gordon

Floor Polishers questions, answered by experts

Buffing will only remove scratches at the surface level of your flooring. You may also need to apply hardwood floor wax to restore the wax layer. To remove deeper scratches, you’ll need another floor repair method like sanding; however, if you sand the floor, you’ll also need to stain and seal it.

You can use dish soap mixed with warm water to clean just about any type of flooring, and while vinegar is a great addition to some floor cleaners, it’s not a good idea to use it on wood flooring or engineered wood flooring. Vinegar is very acidic, and it can gradually eat away at the protective finish on wood floors. If you’re cleaning laminate, tile, concrete, or vinyl floors, feel free to use vinegar and water in a 1-to-1 ratio with a few drops of dish soap. For wood floors, substitute the vinegar for olive oil.

If your floor is still sticky after mopping, chances are you used too much or too little of the cleaning solution. Using too little won’t get all of the grime off, but using too much can leave its own residue. Refer to the cleaning solution’s instructions and dilute it as directed.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Sweep daily, use appropriate cleaners, and avoid abrasive tools to maintain the shine.

The Gordon, WI homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles