Top-rated pool and spa technicians.

Get matched with top pool and spa technicians in Frederic, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Frederic, WI?

Select your specific project to find the pro for you.

Find Pool and spa technicians in Frederic

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Frederic, WI and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Pool and Spa Servicing questions, answered by experts

No, you cannot clean your hot tub filters in the dishwasher. While it may seem like a good idea, the dishwasher soap isn’t gentle enough for hot tub filters and can damage them. Gentle cleaning is better when cleaning the hot tub filters and keeping them intact.

Regular water testing, filter cleaning, and chemical balancing are essential for keeping water clean and equipment functional.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

If you don’t clean your hot tub filters, they’ll build up dirt and grime, preventing them from filtering out contaminants like dirt and bacteria. The dirty water will then circulate through the filter and back into the hot tub, leading to dirty water, a damaged pump and jets, and low heat. This can lead to higher hot tub costs because you may have to pay for repairs.

Generally, it is more cost-effective and energy-efficient to leave your hot tub on all the time rather than turning it on and off. Reheating a hot tub from a cold temperature consumes a significant amount of energy, so maintaining a constant temperature is usually more economical, especially with frequent use.

For daily or weekly use, it's recommended to keep the water at a constant, reduced temperature, such as between 80 and 95 degrees Fahrenheit, and then increase it to your desired temperature before getting in. If you know you won't be using the hot tub for an extended period, you can lower the temperature to save on energy costs. However, if you use it very infrequently, you can turn it off completely, as long as there is no risk of the water freezing.

The Frederic, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.