Top-rated floor polishers.

Get matched with top floor polishers in Egg Harbor, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Egg Harbor, WI?

Select your specific project to find the pro for you.

Find Floor polishers in Egg Harbor

Avatar for Floor Shine LLC
Floor Shine LLC
5.0(
5
)
Clean & Polish Flooring - For Business

Serving Egg Harbor, WI and surrounding areas

In business since 1993

"Mike, with Floor Shine, was priced affordably, was extremely reliable, and exceeded expectations! I hired him from out of state to clean my elderly mother’s carpets and tile grout. My mom has two geriatric dogs, and SIX cats. Mike stuck to his original bid, despite all the pet stains and odor. He showed up right on time with both his visits to the home. My mom felt extremely comfortable with him, and his professionalism. I would recommend Mike, and his company, Floor Shine, to EVERYONE in the North Central Florida area!"
Bleached spot repair caused by pool chemical
Bleached spot repair caused by pool chemical
Bleached spot repair caused by pool chemical
Additional Photos
Additional Photos

+16

Recommended by100%of homeowners
Floor Polishers questions, answered by experts

Professionals use HEPA vacuums, industrial-strength cleaners, and microfiber cloths for effective cleaning without damaging surfaces.

Regular sealing, proper drainage, and periodic inspections prevent premature wear and cracking.

Post-construction cleaning services typically include debris removal, dusting, vacuuming, wiping and sanitizing surfaces, window cleaning, and floor polishing. Depending on the scope, services may also extend to duct cleaning and general interior cleaning.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

The Egg Harbor, WI homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.