Top-rated pool and spa technicians.

Get matched with top pool and spa technicians in Argyle, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your pool and spa servicing project in Argyle, WI?

Select your specific project to find the pro for you.

Find Pool and spa technicians in Argyle

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Above Ground Swimming Pool or Accessories - Repair or ServiceHot Tub or Spa - Repair or ServiceIn Ground Swimming Pool or Accessories - Repair or Service+6 more

Serving Argyle, WI and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Pool and Spa Servicing questions, answered by experts

If you don’t clean your hot tub filters, they’ll build up dirt and grime, preventing them from filtering out contaminants like dirt and bacteria. The dirty water will then circulate through the filter and back into the hot tub, leading to dirty water, a damaged pump and jets, and low heat. This can lead to higher hot tub costs because you may have to pay for repairs.

When your hot tub is completely dry, there is typically no need to introduce antifreeze into the plumbing. However, if you desire an extra layer of protection against potential freeze damage, you can consider adding some RV antifreeze to your hot tub lines. Just ensure that you use RV antifreeze specifically, as automotive antifreeze is highly toxic and should be avoided.

A compact unit designed for two to three people typically weighs approximately 500 pounds in its empty state. On the other hand, a larger hot tub meant for up to six people can weigh around 1,000 pounds when empty. Materials used also impact weight. Less expensive hot tubs are typically lighter because they are made of molded plastic or fiberglass.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

When your hot tub is not in use, you can keep it at a constant soaking temperature of around 100 degrees Fahrenheit. For extended periods of non-use, you can lower the temperature by about five degrees. This slight decrease makes it easier and quicker to heat back up to a desirable level when you're ready to use it again. Additionally, you might consider lowering the temperature by a couple of degrees during the summer to avoid feeling overheated.

The Argyle, WI homeowners’ guide to pool and spa services

From average costs to expert advice, get all the answers you need to get your job done.