Get matched with top epoxy flooring pros in Eltopia, WA

It takes time for damage to accumulate on garage floors. After years without maintenance, they will show cracks, stains, and moisture damage while collecting layers of dust along the surface.

Yes, you can seal an old concrete floor as long as you remove stains and repair damage before sealing. Remove everything from the garage and clear the floor throughout with a concrete cleaner and power washing. Fill in cracks larger than 1/8 of an inch wide and remove all grease and rust stains before sealing. Make sure your concrete is fully dried before applying sealer.

Flooring professionals can typically apply epoxy within one or two days, depending on how much preparation or repair the old floor needs before application. However, you’ll need to wait after the application is complete to use the flooring. While you can walk on the epoxy flooring before it fully cures, it can take up to 72 hours for the epoxy floor to fully dry and be ready for full use.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.