Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Middlebury, VT

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Middlebury, VT?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Middlebury

Avatar for Vermont Pressure Washing - Home  Facebook
Vermont Pressure Washing - Home Facebook
4.6(
8
)

Serving Middlebury, VT and surrounding areas

In business since 2007

Free estimates

Credit card accepted

"They were very professional and dedicated. Some of the decks were in pretty bad shape. They stayed on it until all old mold was out. One of them was in sch bad shape that when it was wet it was dangerous. Well now it looks like new. Very nice work. Thank you!"
Dryer vent
Dryer vent
Dryer vent
Saint Johnsbury pressure washing
Saint Johnsbury pressure washing

+21

Response time3 days
Recommended by100%of homeowners
Dupont Pressure Washing
4.5(
2
)

Serving Middlebury, VT and surrounding areas

In business since 2004

Free estimates

"Provider did an excellent job once we were finally able to get him to come over. He was not familiar with the deck stain I bought so in turn we did not get the two coats applied like we wanted. This is partially my fault due to me not informing him that the two coats need to be applied Wet on Wet (applied within 20 minutes of each other). Other than that he showed up when he said he would and performed the work, and a little extra, in a timely and professional manner.
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+6

Recommended by100%of homeowners
Showing 1-10 of 21
Deck Maintenance questions, answered by experts

Staining and sealing the underside of a deck creates a moisture barrier but traps water in the boards, quickly leading to rot. No matter how well you seal the above deck, water still gets through via nails and screw heads on the surface. Allow this water to flow naturally under the deck, where it is routed through the drainage system.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

The most likely causes of a deck leaning to one side are damaged deck posts, soil erosion, and inadequate deck footings. If you’re not sure about the exact cause, the best option is to call a contractor who can build a deck to inspect the damage and recommend the best way forward.

Expect to spend around $10,000 to $11,000 to replace a 20-by-20-foot deck. Using high-end materials like composite or exotic hardwoods can drive up the cost, as can custom features and design elements. You can also expect to pay more than average if your deck replacement requires a site evaluation or if you need the work done during the busy season.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

The Middlebury, VT homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.