Best concrete driveway pros near Wendover, UT

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

Yes, you can and should pressure wash a stamped concrete driveway, as well as other stamped concrete around your yard on the patio or walkways. While the stamping pattern can handle the pressure of the water, it's still best to use a gentle solution to avoid breaking down the concrete or affecting any additional stain coloring added to the design.

If your epoxy application ended up a bit messy and left spills behind, there are several ways to clean epoxy off of a concrete floor. You can use a power washer with at least 3,000 PSI. However, it may be easier to use a scraping tool or an acidic cleaner, like vinegar, to remove unwanted epoxy. 

If the entire floor has epoxy and you want to remove just excess epoxy stains, these methods could still strip parts of the epoxy floor. Move carefully and in small areas to minimize damage, or call a pro for an expert finish.