Best well and pump technicians near Roy, UT

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

Here are some signs of a bad well pump that a pro should look at: 

• If your well pump isn’t pumping water, you could have a leak or malfunctioning pump on your hands. 

• If your water pump runs nonstop, there might be a leak or problem with the pressure tank, which can cause the pump to fail. 

• Low water pressure can happen because of your pressure tank, low-water levels, or a wrong-sized pump. 

• Dirt or sediment in your water can be a problem with a powerful pump, damaged pump filter, or the pump’s location.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.

If you notice any changes to the water coming from your well, consider that a sign to get a well inspection. For example, if the water is foul-smelling, bad-tasting, cloudy, or discolored, you should call a pro. It’s also a good idea to schedule an inspection if you observe a loss of water pressure, broken equipment, loss of well capacity, or other unusual signs.