Get matched with top floor cleaners and waxers in Kearns, UT

You can mop bamboo floors, but exercise caution to protect the material from excess moisture, which can seep into the bamboo, causing it to warp and well. Moisten a microfiber mop and wring it out until it’s just damp, or use a pH-neutral cleaner, as this will prevent damage to the bamboo fibers. Avoid harsh chemicals, like traditional floor cleaners. After cleaning, wipe the floor dry.

You can use dish soap mixed with warm water to clean just about any type of flooring, and while vinegar is a great addition to some floor cleaners, it’s not a good idea to use it on wood flooring or engineered wood flooring. Vinegar is very acidic, and it can gradually eat away at the protective finish on wood floors. If you’re cleaning laminate, tile, concrete, or vinyl floors, feel free to use vinegar and water in a 1-to-1 ratio with a few drops of dish soap. For wood floors, substitute the vinegar for olive oil.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.