Get matched with top locksmiths in Garland, UT

Lock bumping is a technique locksmiths use to quickly and quietly open a pin tumbler lock, typically found in most types of deadbolts. It involves inserting a specially crafted key, or bump key, into the lock and tapping or "bumping" it with a mallet or similar tool. The force applied causes the lock's pins to jump momentarily, allowing the lock to be turned and opened. Unfortunately, thieves also use this technique to break into homes. Luckily, products like a deadbolt strap will fortify your lock.

Thieves can open almost anything with enough time and the right tools, but they also prefer easy targets that are unlikely to get them caught. Forcing open gates is loud and difficult, and to be able to open one electronically requires extensive knowledge of the system, which most thieves don't have. Electric and other security gates are great deterrents because the thief will move to an easier target. If the thief is determined to enter your property, they will most likely find a different entrance point.

When you take a key to a hardware store or a locksmith for copying, you can expect the key-cutting process to take as little as 30 seconds. The key copier will review your current key to decide on the correct blank. Then, your original key and the blank are inserted into a key duplication machine to cut an exact key copy. When it’s all said and done, you can have a new key in your hand in just a couple of minutes.

It’s possible, but depends on the design of your lock. Some door locks that lack a keyhole do boast a small hole on the exterior handle or knob. This hole’s primary function is to allow water to drain out of the lock, in addition to giving homeowners an easy spot to insert lubrication. However, you can typically use a paperclip in this pinhole to unlock the door by manipulating the mechanism inside.