Best boiler installation pros near Elk Ridge, UT

"Kevon is extremely knowledgeable and skilled at boiler and radiant heating troubleshooting and repair, able to keep an old system alive long enough to get a new one installed Doesn't try to sell a replacement when a repair is practical and justified Replacement quote is very competitive and proposes high quality products and components"

"Fast, efficient, and quality service at a reasonable price."

"Very clean and professional. Work was completed in less than a day. Ryan noticed that the original gas line to the garage was installed incorrectly and he corrected it at no additional cost."

"They installed a mini split. The exterior placement of the compressor we were not happy with. They came back immediately and corrected the problem. We are happy with the results."

"Fast, friendly & reliable!! 10/10 highly recommend!!"

We pride our company on reliability, great communication, integrity, and quality work. We are experts in our trade and will do our best to keep you as educated as we can on your particular task or project. We look forward to earning your business! Book with us online or feel free to give us a call today! \n

"Tyler recycled the heater, which got it started again. After a week it is still working properly. No charge for the service."

"They have a really friendly guy name Mike who came out to the house and installed the furnace. He helped fill out the paper work, so that I could get a rebate from the state and another company. He also made sure I had the right paper work that I could submit for my federal taxes for next year. I spent $2700 on that work. They were very responsive and professional."

"Utah Heating and Cooling are so fast and efficient and really care about their customers. I will definitely be calling them again!"

"Dan from Expert Plumbing called me about 10:15 AM on the day of the new shower installation to get some additional information on what I needed done, and then again when he was about 10 minutes out. When he arrived, just shortly after 11 AM, he went over Expert's pricing (i.e., cost of the service call, hourly rate and minimum,etc.) and after looking very briefly at the plumbing, had me sign an invoice assuming two hours of labor (the worst case scenario in his mind). However, he explained that if he completed the work in an hour or less he would write up another invoice for one hour minimum labor charge. Dan then looked at the now exposed plumbing behind the bathtub. He saw no evidence of any leakage along the bathtub piping or on the floor during a careful inspection. However, he was unable to pressure test the piping and soldered connections because the water had been turned off and the shower-install contractor had already cut the copper piping to the now-demolished shower. He then focused on the corroded (due to hard water) nipple. It took some effort but with the correct internal pipe wrench he was able to remove it. I had purchased four nipples of differing lengths in anticipation of replacing the corroded nipple. Dan installed one of the new nipples so that a new tub spout with a threaded connection can be installed. Overall, the labor he performed took around 45 minutes, with most of that time expended on removal and replacement of the recalcitrant corroded nipple. In summary, Dan was courteous, personable, and professional. Before leaving he modified the invoice to one hour of labor, as he had discussed upon arrival. I would use Expert Plumbing, Heating, Air, and Electrical again if needed."