Get matched with top cabinet makers in Cedar Valley, UT

Most cabinetry made for a garage will have special coatings and finishes built to withstand extreme heat and cold, moisture, pest damage, rusting, and dry rot. However, many homeowners have put their old kitchen cabinets in the garage, added a couple of fresh coats of paint, and use them for a while without too much wear and tear.

If you’re brave enough to tackle building your own cabinet bases, you’re brave enough to install them yourself. You’ll need a stud finder to get you started, but the installation will be a breeze if you’ve already done all the hard work to build the cabinet bases yourself. If you’re hanging upper cabinets, you’ll need a helper, though, to balance the weight of the cabinets and make the process easier.

It is typically cheaper to buy stock or semi-custom cabinets than to build custom ones. The price difference is significant:

• Custom Cabinets: Cost between $500 and $1,200 per linear foot. This price is affected by materials, size, design complexity, and door styles. For instance, a simple slab door's materials might cost $60-$70, while a decorative mullioned glass door could be $100-$200.

• Semi-Custom Cabinets: Cost between $150 and $700 per linear foot.

• Stock Cabinets: Cost between $100 and $400 per linear foot.

While buying pre-built cabinets is more cost-effective, building custom cabinets allows for full modification to fit unique spaces, such as rooms with high ceilings or unusual layouts, which stock options cannot accommodate.

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.