Top-rated floor polishers.

Best floor polishers near Watauga, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Watauga, TX?

Select your specific project to find the pro for you.

TRUSTED BY WATAUGA, TX HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon115
    Verified floor polishing services reviews

Top-Rated Floor polishers in Watauga - Updated Nov 2026

Avatar for Ace Carpet Cleaning and Water Restoration
Ace Carpet Cleaning and Water Restoration
4.9(
154
)
Clean & Polish Flooring - For Business

Serving Watauga, TX and surrounding areas

Approved

In business since 2005

Free estimates

Emergency services offered

"Travis Mullins went the extra mile scrubbing the floors. He got rust off the office floor that had been there for over a year. Set in stains became lighter. Great work by a hard working professional. I appreciate his work and Matthew Brooke for sending him. Thank you."
Travertine/Marble Polishing
Travertine/Marble Polishing
Travertine/Marble Polishing
Additional Photos
Additional Photos

+19

Response time12 hrs
Recommended by91%of homeowners
...
Showing 1-10 of 187
Floor Polishers FAQs, answered by experts

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Yes, a magic eraser can remove candle wax. You can use it to remove all the candle wax from start to finish. Another option is to remove all large clumps with a dull knife and then pull out your magic eraser to finish the job. However, while the results can be impressive, a magic eraser shouldn’t be used on all surfaces since it can potentially damage them. If you try this method, test a small, hidden spot first and proceed cautiously.

While it is not recommended, you can mix Bon Ami with vinegar for a more powerful cleaning mixture. However, you should avoid mixing other types of powder cleaners, such as Comet and Ajax, with vinegar or with each other, as the reaction often creates a toxic gas that’s dangerous to the human body.

Yes, you can polish an old cement floor. However, be aware that the first pass with the concrete grinder may reveal a few surprises and imperfections. You may also have to contend with the consequences of previous floor coverings, such as tile or carpet, which can leave a pattern in the concrete. Old concrete is more likely to produce uneven results if you want to use a dye or other coloring.

The Watauga, TX homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.