Top-rated drywall pros.

Get matched with top drywall pros in Sunrise Beach, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall service project in Sunrise Beach, TX?

Select your specific project to find the pro for you.

Find Drywall pros in Sunrise Beach

Avatar for Bernabe&sons drywal
Bernabe&sons drywal
3.0(
1
)
Drywall - InstallDrywall - Repair

Serving Sunrise Beach, TX and surrounding areas

Approved

Free estimates

Emergency services offered

Small jobs welcome

My name is Bernardo bernabe i have been in the drywall business for about 7 years.\nI do jobs all over the san antonio area and surrounding areas I specialize in doing remodels and new construction houses, including small patch work, no job is ever too small or too large, text for a free quote!

Home's Paint & Maintenance
4.0(
2
)
Drywall - Repair

Serving Sunrise Beach, TX and surrounding areas

Approved

In business since 1998

Free estimates

Customers say: Quick response

Here at Home's Paint & Maintenance, we are a locally owned and operated company that values honesty and integrity and treats your home as if it were our own. We offer a variety of quality home improvement services. You will find us to be competitivelypriced with close attention to the details of each and every project that we are involved with. We look forward to building lasting relationships and guarantee your satisfaction!\n

Casa en Marble Falls
Casa en Marble Falls
Casa en Marble Falls
Casa en Austin Tx
Casa en Austin Tx

+35

Response time4 hrs
Response rate100%
Recommended by100%of homeowners
BluSky NM Drywall Lath & Plaster Inc
4.8(
249
)
Drywall - InstallDrywall - Install - For BusinessDrywall - Repair+1 more

Serving Sunrise Beach, TX and surrounding areas

In business since 1994

Free estimates

Emergency services offered

"The crew showed up every morning on time. They patched/drywalled and textured numerous small areas. The texturing was so good, that it is almost impossible to detect where the repairs where made. They also framed, drywalled and textured the kitchen area for recessed lighting installation. They repaired an area where there was a shower leak. They replaced the drywall and textured an area where a closet had been removed. On every part of the project, they exhibited superior workmanship. And at the end of every day, they cleaned up after themselves. Hire them again? Definitely yes! 
"
Additional Photos
Additional Photos
Additional Photos
Recommended by98%of homeowners
Avatar for S J Painting and Drywall
S J Painting and Drywall
4.6(
13
)
Drywall - InstallDrywall - Repair

Serving Sunrise Beach, TX and surrounding areas

In business since 2015

Free estimates

"Sergio did an excellent job restaining our dront door and cedar posts that had naturally faded from sun exposure over the years. He matched the original stain perfectly, and his service was polite and professional."
My Work
My Work
My Work
My Work
My Work

+41

Response time3 days
Recommended by30%of homeowners
...
Showing 1-10 of 77
Drywall questions, answered by experts

While it’s most common to sand plaster dry, it is possible to wet-sand plaster, too. Doing so can reduce the amount of plaster dust released into the air and make it easier to work in smaller, more delicate areas (such as around wall trim). However, some people find that wet sanding leads to more imperfections, which is why larger walls are more often dry sanded to ensure an even finish.

Yes, you can hammer a nail into a wall stud. But before you do, it’s important to confirm that you’re actually nailing into a stud—and not wiring, pipes, or ductwork. To check, find a few more studs in the wall, then measure to make sure they’re either 16 or 24 inches apart.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Most drywall used for interior walls of homes is 1/2-inch thick. This size strikes a balance of being easy to handle and hang while being thick enough for the durability needed on interior wall applications.

Plastering and skimming are two different techniques for finishing walls. Plastering involves applying a thick layer of a plaster mixture—typically containing gypsum, lime, cement, sand, and water—to create a new surface. This process often requires multiple coats and is used for repairing significant damage or creating decorative textures. Skimming, on the other hand, is a technique that involves applying a thin layer of drywall compound or joint compound over an existing surface to smooth it out, covering minor imperfections, small cracks, or uneven textures for a polished look. Plastering is generally more costly and labor-intensive than skimming. Although some people use the terms interchangeably, they refer to different processes and materials.

The Sunrise Beach, TX homeowners’ guide to drywall services

From average costs to expert advice, get all the answers you need to get your job done.