Top-rated contractors.

Best contractors near Stanton, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Stanton, TX?

Select your specific project to find the pro for you.

Top-Rated Contractors in Stanton - Updated Nov 2026

Avatar for The Basement Kings
The Basement Kings
4.8(
16
)
Major Home Repairs (General Contractor)

Serving Stanton, TX and surrounding areas

In business since 2004

Emergency services offered

Credit card accepted

"I have had over 30 contractors at my home as it has been basically rebuilt.  This company has been the most professional i have dealt with.  Showed up on time, communicated progress, cleaned up at the end of each day COMPLETELY, came with all necessary tools and supplies.
Along the width of the house, all of the walls were removed from the floor to aprox 2 feet.  Lower portion of studs and base plates removed, walls sealed with amazing product, studs, base plate and walls replaced (not the sheetrock).  All lower level floors sealed.
We have had over 5" of rain in the last 24 hours.  This is the first time since i have owned this house that the floors have not flooded when we have saturated soil and heavy rain. 
Incredible product, excellent company.  i highly recommend both.
"
Recommended by92%of homeowners
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Stanton, TX and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
...
Showing 1-10 of 73
Unfinished Carpentry FAQs, answered by experts

Yes, professionals can install new frames, trim, and threshold adjustments for a complete finish.

Joists do distribute their load to beams, but they don’t sit on top of the beams. Instead, home builders nail or screw the joists directly to the beams such that the end of the joist butts up against the edge of the beam. Beams can sit on other beams for support, but you’ll never see a joist sitting on top of a beam or another joist.

Your local building code will list all the framing requirements for whatever type of structure you're building. Most exterior walls require spacing of 16 inches on-center, while many non-load-bearing interior walls only require 24 inches of spacing. However, there are also varying requirements depending on your construction material, so checking your municipality's rules is essential.

In framing, studs are placed at 16-inch intervals to coincide with the typical spacing of wall materials such as drywall or plywood. This spacing is called "on-center" and is necessary for maintaining structural stability and efficient use of materials. The 16-inch spacing also helps to distribute the weight evenly across the building's structure. For those looking to cut material costs and improve energy efficiency, 24-inch stud spacing can be employed through a method called "advanced framing". This requires careful planning and adherence to local building codes to ensure structural integrity.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

The Stanton, TX homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.