Top-rated contractors.

Get matched with top contractors in Rankin, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Rankin, TX?

Select your specific project to find the pro for you.

Find Contractors in Rankin

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Rankin, TX and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Rankin, TX and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Dan's Roofing and Painting
3.8(
32
)
Major Home Repairs (General Contractor)

Serving Rankin, TX and surrounding areas

In business since 1984

Free estimates

Emergency services offered

"Mr. Munoz helped me file my insurance to have my roof replaced. I'm very grateful he came to my door that day. His workers were in and out in one day, as promised, and they cleaned up their work area so well that you wouldn’t have known anyone had been there. I'm so very grateful for the completed services."
Additional Photos
Additional Photos
Additional Photos
Recommended by73%of homeowners
Showing 1-10 of 31
Unfinished Carpentry questions, answered by experts

When hanging a door frame, it’s recommended that you use screws, not nails. Screws are more secure, easier to tighten, and easier to remove if you need to adjust the frame. On average, the cost to replace a door frame is about $400, but you can save on labor costs if you’re confident in your ability to DIY the project. 

There are a few easy ways to locate a wall stud without a stud finder. First, try knocking on the wall with your knuckles. Most parts of the wall will sound hollow, but when you tap over a stud, it will sound more solid. Alternatively, since studs are spaced 16 or 24 inches apart, you can measure those distances from a corner of the room, which will always have a stud.

A cross brace for a fence gate should stretch from the top corner of the gate’s hinge side to the bottom corner of its latch side at a 45-degree angle to the bottom of the gate. This positioning distributes the bulk of the gate’s weight to the base of the post, taking pressure off the top hinge.

Bump-out additions can extend anywhere from 2 to 15 feet from an existing room. The right size will depend on how you plan to use the new space. For a cantilever bump-out, which doesn't require additional foundation support, the limit is typically 24 inches (2 feet). If a footing and foundation are part of the project, a bump-out can be much larger, even encompassing a whole room. It's also important to remember that many residential properties have limits on the total house size relative to the lot size.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

The Rankin, TX homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.