Top-rated affordable plumbers.

Get matched with top affordable plumbers in Runge, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your affordable plumbing project in Runge, TX?

Select your specific project to find the pro for you.

Find Affordable plumbers in Runge

Avatar for Hill Country Tub and Shower
Hill Country Tub and Shower
5.0(
34
)
Shower Install or ReplaceBathtub Install or Replace

Serving Runge, TX and surrounding areas

Approved

In business since 2023

Free estimates

Warranties offered

"I have a 51 year old bathroom and they turned it into a modern stunning oasis. Phil and B were the ultimate professionals. They did an amazing job with such attention to detail and pride in their work. The trim work was superb. They showed respect to me and my opinions. I would hire them again for any future jobs."
onyx shower
onyx shower
Tub to Tub
master bath
onyx shower

+1

Response time7 hrs
Response rate99%
219 neighbors recently requested a quote
Avatar for Port Lavaca Plumbing
Port Lavaca Plumbing
5.0(
7
)
Shower Install or ReplaceSewer Main - Install, Replace or RepairWalk In Tub - Install or Replace+9 more

Serving Runge, TX and surrounding areas

Approved

In business since 2023

Free estimates

Credit card accepted

"Highly recommended! I had a rental property that needed extensive work and Marcus and his team completed the project quickly & professionally. Very affordable for the amount of work completed and the most affordable in the area that I found out of 3 other companies. Definitely satisfied with the results and experience!"
9 neighbors recently requested a quote
Avatar for Groundworks
Groundworks
4.5(
205
)
Sump Pump or Interior Foundation Drains - Install

Serving Runge, TX and surrounding areas

Approved (Corporate)

In business since 2016

Free estimates

Warranties offered

"FSS finished our house repairs within 5 days. They are affordable and priced competitively. FSS offers lifetime warranty. They answered our questions and respond to us in a timely manner. The crew covered main areas to reduce dust to minimal. They even cleaned up after the end of each day and asked us if we had any further questions. Holes were covered up to ensure safety. When job was completed, the holes were either covered up with cement or dirt, depending on the area where the hole was dug or drilled. I recommenced FSS, there professional and prompt."
Foundation
Foundation
Foundation
Concrete
Concrete

+15

Response time1 day
303 neighbors recently requested a quote
Recommended by88%of homeowners
Avatar for American Standard Walk-In Tubs
American Standard Walk-In Tubs
3.8(
55
)
Walk In Tub - Install or Replace

Serving Runge, TX and surrounding areas

Approved (Corporate)

In business since 1929

Free estimates

Credit card accepted

"Getting a walk in tub is expensive no matter who you use. My experience thus far is with installation only and I must say my install went great. It has been over a month and no issues with my tub so I cannot comment on repair process with American Standard."
Walk-In Tub
Walk-In Tub
Walk-In Tub
Walk-In Tub
Walk-In Tub

+1

Recommended by90%of homeowners
...
Showing 1-10 of 52
Affordable Plumbers questions, answered by experts

The lifespan of insulation depends on the material type. Fiberglass can last between 80 and 100 years, but it is important to start checking it around the 15-year mark. Spray foam has a lifespan of up to 100 years, and mineral wool can last up to 100 years. Cellulose, an eco-friendly option, has a lifespan of 20 to 30 years.

Local building codes sometimes require sewer ejector pumps to have their own vents. If so, these dedicated vents run upward through the home and exit through the roof. Otherwise, the pump’s vent pipe can connect to an existing vent stack. Regardless of which method you use, venting is an important part of installing a sewer ejector pump because it helps equalize pressure and prevents gases from building up inside your home.

You might think it’s OK to ignore a faucet that drips if it’s not too bad, but doing so can cause more damage. A leaky faucet can also increase water bills and potentially attract bugs and other pests to your home. When you find a water leak, it can result in water damage to your home, which can cause structural issues and mold growth.

Yes, you can change a bathtub faucet without changing the valve, as long as the new faucet is compatible with your existing valve system. Most manufacturers design their faucet trims (handles and spouts) to work with their standard valve bodies. However, you'll need to match the new faucet to your valve type, whether it's a compression, cartridge, or ball-type valve. Mixing brands can be problematic, but you can bring your old faucet parts to the hardware store and ask about compatibility.

The two main types of bathtub faucets are screw-on and slip-on. A screw-on faucet has threads inside and screws onto the pipe, while a slip-on faucet slips onto the pipe and is secured with a setscrew on its underside. You may also encounter other designs, such as freestanding, wall-mount, deck-mount, or other high-end specialized systems. It is important to identify your specific faucet type before attempting removal to avoid damaging the pipes or the wall.

The Runge, TX homeowners’ guide to affordable plumbing services

From average costs to expert advice, get all the answers you need to get your job done.