Best brush chipping pros near Roanoke, TX

Very disappointed with Cole Painting LLC. The job site was left messy every day with open paint cans, dirty brushes and rollers, and equipment scattered around. I constantly had to clean up after the crew. The workmanship was below professional standards. There was paint and texture overspray,...

I believe they cut corners. They move something for me that was not in the scope of their practice damaged my wall in my house and didn?t take ownership to it, but I didn?t even hold that against them. It?s the fact that I went to mop my new floors that they put in the garage with the epoxy, and...

Very reliable; professional and punctual. Cleaned up all the brush. Definitely would hire again. Highly recommend.

We have used Sharp Refinishing before and had them come out to fix a chip in our upstairs tub. Jim is always a pleasure to work with and as usual his workmanship is excellent. Highly recommend them for any tub refinishing work!

The job was done well. Prepping and painting by brush and roller. Very pleased with the work.

They did a very good job repairing the chip and crack in my countertop. You can't see the crack at all. Nice guys too.

I hired this contractor for my kitchen cabinet painting, overall finish is not good, it's just ok. I could have done myself better than this quality of paining as beginner DIY, since the volume of job was high I had to hire this contractor. They did not paid attention to fill the minor...

Did not sand moulding before painting so now the new paint is chipping off. Cabinets are all cracking at the seams and also did no prep work on new cabinets to make sure that the paint would go on smoothly

They did an excellent job. Masked, taped, protected and prepped all areas. Completed minor spackling. Removed all hardware and replaced hardware at completion. Good coverage of paint. Doors and trim painted without brush strokes.

This person is very punctual and is very good about communicating what he is doing and when it will happen. He cleaned up after himself as much as possible without causing problems with the finishes on the tops. The product he used covers cracks and small chips quite well but not the areas where...